Spinner Rubber replacement

[Steven Campbell]

I have a couple of Williams SS games that have spinners. on them.. The outside frame gate was all bent up so I decided to pull them off, put them in the vibrator or whatever it's called, and then carefully bring them back to the design they are suppose to be.

They have vertical legs and on the legs are round rubbers that are pretty tall. My problem is I can NOT figure out how to get them off. The long screw they are on is something I cant remember if it comes apart.

The bottom is a normal looking screw that goes down into the playfield then there is a round flange that is a bit bigger, then the round rubber then on to[p of that is another round oversized flange.

So, any help would be appreciated very much!!!!

thanks

[John Robertson]

Post by Steven Campbell
I have a couple of Williams SS games that have spinners. on them.. The outside frame gate was all bent up so I decided to pull them off, put them in the vibrator or whatever it's called, and then carefully bring them back to the design they are suppose to be.
They have vertical legs and on the legs are round rubbers that are pretty tall. My problem is I can NOT figure out how to get them off. The long screw they are on is something I cant remember if it comes apart.
The bottom is a normal looking screw that goes down into the playfield then there is a round flange that is a bit bigger, then the round rubber then on to[p of that is another round oversized flange.
So, any help would be appreciated very much!!!!
thanks

Those rubber sleeves should just pull off straight up when the screw on
the top is removed. Might be a bit tight due to age, but that was the
intent - slide up and off.

John :-#)#