I did something stupid..i think

[diana anderson]

Picked a a reimport and decided to cut the plug off and use a standard 2 prong home depot plug..Plugged it in and fryed some fuses replaced the fryed fuses and not sure what to do now will putting back in the right plug work or did i fry more than just a few backbox fuses i dont want to waste alot of time and $ on this machine as it will need alot of cosmetic work done on it as well but if the driver board is fryed its in the scrap pile

[John Robertson]

Post by diana anderson
Picked a a reimport and decided to cut the plug off and use a standard 2 prong home depot plug..Plugged it in and fryed some fuses replaced the fryed fuses and not sure what to do now will putting back in the right plug work or did i fry more than just a few backbox fuses i dont want to waste alot of time and $ on this machine as it will need alot of cosmetic work done on it as well but if the driver board is fryed its in the scrap pile

Where are you located, and where did the machine come from?

How do you know you wired up the power plug correctly if you didn't
check first to see if the game was wired for 120 or 220 VAC operation?

The game may also have problems from before you bought it.

I would recommend first check the power cord to make sure it is wired as
the factory says for 120VAC.

Next check the jumpers are set up for 120VAC (or 220 if in a country
that needs that).

Then check the fuses - line fuse first as the value for that depends on
the line voltage.

Lastly check if there is a line voltage MOV in the game. That may be
shorted...

Lastly, what the heck is the game make and model? That is really useful
info!

John :-#)#